ClassicFlame 36EB110-GRT Guia de Instalação

Electric Builder Box E-1CONSUMER SAFETY INFORMATIONPLEASE READ THIS MANUAL BEFORE USING THIS APPLIANCEWARNINGThank you and congratulations on your pur

E-10 Figure 10SECTION 6: INSTALL CONTROL BOX1. Mount the control box bracket to the wall using provided screws.2. Connec

SECTION 6: CHECK & TEST1.) Recheck that all the wiring works. Check that all connections are tight and correct to the manual.2.) Switch on

SECTION 10: WIRING SCHEMATICE-1236EB110-GRT

36EB220-GRT E-13

E-1436EB111-GRC

36EB221-GRC E-15

LISTINGS AND CODE APPROVALSTHE BUILDERS BOX SERIES HAS BEEN TESTED AND APPROVED IN ACCORDANCE WITH CSA AND UL STANDARDS FOR FIXED AND LOCATION DEDICAT

SECTION 1: PREPARATION1.) Open the master carton, stone box , and wall mounted control box and make sure you have all the parts listed. Remove t

E-4 Figure 3 Figure 2STEP 1UNSCREW 2 SCREWSSTEP 2LIFT FRONT PANEL36EB110-GRT36EB220-GRT 36EB111-GRC36EB221-GRC 2.) Unscrew 2 screws on the side edge

Section 1: Framing Framing Specification: Figure 3 SECTION 2: FRAMINGE-5MODELA B C D E F G H I J K L M 8” 35”

E-6Figure 4: Mounting Tab LocationFigure 5: Wall and Mounting TabsSECTION 4: MOUNTINGInstall Method：1.) Remove front frame (see figure 2).2.) Remove t

Figure 6: Mounting Tab LocationFigure 7: Wall and Mounting Tabs36EB110-GRT36EB220-GRT 36EB111-GRC36EB221-GRC Place stones here.E-74.) Install the bu

SECTION 5: 120V WIRING INSTRUCTIONS1.) Loosen the screw securing the junction box cover and remove the cover.2.) Pull the power supply wires through

Figure 9E-9CONTROLSECTION 5: 208/240V WIRING INSTRUCTIONS1.) Loosen the screw securing the junction box cover and remove the cover.2.) Pull the power